Pontoon Boat Steering System

Quickly and easily replace the steering system on your pontoon boat.  Rotary pontoon boat steering systems cut installation time in half and occupies minimum space behind the dashboard; mounts perfectly to our pontoon boat consoles.

• Standard 3/4" tapered shaft.
• Three turns to lock for standard travel.
• All Stainless Steel ends to minimize corrosion.

Can be used on pontoon boat engines up to 140HP and any pontoon boat with an inboard/outboard (I/O) engine. 

* cannot be installed on pontoons with thru-transom OMC engines.

Our steering system contains: 

• Pretech rotary helm.
• Steering cable.
• 90° degree bezel and all installation hardware.

*Steering wheel sold separately.

Measuring For Your Steering Cable

When replacing the steering system on your pontoon boat you will need the following measurements to determine the cable length.

A.   Measure from the center of your pontoon's console to the edge of the starboard side of your deck. 

B.   Measure your pontoon boat's deck length from the center of your console to the point where your engine is attached to the transom.

C.   Measure from the starboard edge of your deck to the center of your transom.

Add A,B, C + 12", round up to the closest foot and that's the length you need.