4 Piece Bass Boat Seats (Set of 2)

Factory-Grade 22.5" Bass Boat Replacement Seats – Pair

Upgrade your boat’s appearance and comfort with these factory-grade, plush 22.5" wide bass boat seats. Sold in pairs, each set includes a two-piece design for straightforward installation on any platform size. Ideal for restoring older boats or upgrading worn-out seating, these replacement seats offer professional fit and finish.

Key Features

• Two-piece design: Backrest and seat cushion mount separately for easier handling
• Plush 22.5" width for optimal comfort and support
• Compatible with any size platform
• Fold-forward seat cushions allow easy access to under-seat storage
• Pre-installed hinges and vinyl flaps for clean installation
• Center backrest cushions attach with Velcro
• Includes stainless steel mounting screws

Installation Instructions

1. Remove Edge Protectors
   • Pull out the temporary plastic edge protectors from the upholstery. This won’t damage the seat.
2. Mount the Backrest
   • Identify the driver’s bucket seat location and align the backrest against the rear wall of the seating platform.
   • Secure it using the included screws. Drilling additional holes into the plastic frame is allowed if needed and won’t void the warranty.
   • Tip: Align all seats before installing if using a center fold-down seat to ensure proper spacing.
3. Install Seat Cushions
   • Line up the seat cushion with the installed backrest to determine correct spacing.
   • Use the attached hinge and matching vinyl flap to mount the cushion.
   • Screw the hinge and vinyl into place—the vinyl flap conceals the aluminum hinge.
4. Mount Center Fold-Down Seat (if applicable)
   • Choose a mounting location and install as above using the built-in hinge and vinyl flap.

Installation Notes

• Pre-drill pilot holes to avoid damaging fiberglass.
• With 2" screws and a ¾" back wall, expect approximately ¼" screw protrusion.
• All mounting hardware is included.